Selling

Pokémon Card Conditions Explained: NM, LP, MP, HP and Damaged

What each card condition means, the defects that drop a card a grade, how to inspect cards quickly, and how to describe condition so buyers trust you.

Updated November 7, 2026 · 7 min read

Condition is the second most important fact about a card after its identity. It decides the price, the buyer's expectations, and whether you get a return. The good news: ungraded condition comes down to five grades and a handful of defects you can learn to spot in an afternoon.

The five grades

These are the standard ungraded conditions used by TCGplayer and most card shops. eBay's trading-card listings use similar tiers with slightly different names.

ConditionWhat it looks like
Near Mint (NM)Looks essentially unplayed. At most minimal edge or corner whitening, or a tiny scratch visible only under close inspection. No creases, bends or dents.
Lightly Played (LP)Minor wear you can see at arm's length: light edge whitening, small scuffs, slight corner wear. Still clean, still bright, no structural damage.
Moderately Played (MP)Obvious wear: noticeable whitening, scratches across the surface or holo, corner rounding. Maybe a very minor crease or dent. Still fine in a sleeve.
Heavily Played (HP)Major wear: heavy whitening, scuffing, creases, or bends. Clearly worn but fully intact and identifiable.
Damaged (DMG)Tears, water damage, ink, heavy creasing, peeling, or missing pieces.

When a card sits between two grades, list it at the lower one. Buyers forgive a pleasant surprise. They don't forgive an overgraded card.

The defects to look for

  • Edge and corner whitening. The most common wear: tiny chips of the blue back showing white. Check the back first, because whitening shows up there long before the front.
  • Surface scratches and scuffs. Tilt the card under a light. Holos and full arts show scratches easily.
  • Creases and bends. Look along the card at a low angle. Even a faint crease that only catches the light drops a card out of Near Mint.
  • Dents and indentations. Small pressure marks, often from rubber bands or binder rings. Run a finger lightly over the surface.
  • Factory defects. Print lines, ink spots, off-centering and rough edges can come straight out of a fresh pack. Condition graders differ on whether these count, so call them out in your listing either way.

How to inspect quickly

  1. Use one bright light. A desk lamp at an angle reveals scratches and creases far better than overhead light.
  2. Back first, then front. Most whitening is on the back. If the back is clean, the front usually is too.
  3. Tilt every holo. Rotate it through the light to catch scratches in the foil.
  4. Check the edges with your eyes, not your thumbs. Handling cards to check them can cause the very wear you're looking for.
  5. Sleeve immediately. Once a card is graded in your head, protect it. Our storage guide covers what to use.

Condition vs professional grading

Raw condition and professional grades (PSA, CGC, Beckett and others, on a 1-10 scale) measure different things. A raw Near Mint card might grade anywhere from a 7 to a 10 depending on centering and tiny surface flaws you'd never notice in a sleeve. Don't describe a raw card as "PSA 10 quality" or "gem mint": you can't know, and buyers know you can't.

Centering in particular matters a lot for grading and very little for raw condition. If a card is noticeably off-center, mention it; collectors who care will price it accordingly.

Describing condition honestly

  • Photograph the actual card, front and back, in good light. For valuable cards, add close-ups of any flaw.
  • Name the grade and the reason. "Lightly Played: light whitening on the back edges, clean front" sets the right expectation.
  • Be consistent. If you sell a lot of cards, use the same standards every time. Consistent grading is how repeat buyers learn to trust you.

Condition also drives price. Our pricing guide covers how to adjust from Near Mint market price to what a played card actually sells for.

As an Amazon Associate, TCG Yomitori earns from qualifying purchases.

Frequently asked questions

What does NM mean on a Pokémon card?

NM means Near Mint: the card looks essentially unplayed, with at most minimal edge whitening or a tiny scratch visible only on close inspection, and no creases, bends or dents.

What is the difference between Lightly Played and Moderately Played?

Lightly Played cards show minor wear like light edge whitening or small scuffs but are still clean and bright. Moderately Played cards show obvious wear: noticeable whitening, scratches across the surface, corner rounding and possibly a very minor crease.

Does a crease make a card Damaged?

Not necessarily. Any crease rules out Near Mint. A very minor crease can still be Moderately Played, a clear crease is usually Heavily Played, and heavy creasing or a crease that breaks the surface pushes a card to Damaged.

Is a fresh pack pull automatically Near Mint?

No. Cards can come out of packs with print lines, ink spots, rough edges, off-centering or even whitening. Inspect pack-fresh cards the same way you'd inspect any other card.

Can I call a raw card PSA 10 quality?

You shouldn't. Professional grades depend on centering and microscopic surface flaws that aren't visible in normal inspection, so no one can reliably predict a grade from a raw card. Describe the raw condition instead.

Keep reading

Spend less time listing, more time shipping

TCG Yomitori photographs a stack of cards, identifies and prices each one, and exports a marketplace-ready CSV.